Need an account?
Got the backup camera in the bumper wired up Today.
Moniter on the back of drivers sun visor.
Inner tailgate mods all but done. I can draw up the outer skin plan for A&A Sheetmetal now.
Right side inner tailgate mods done.
Left inner tailgate mods done.
Had to set back the handle assy 1 inch for outer skin clearance
1 inch setback
Will be covered with spray on bed liner
Finished the weld along the top whilst I was at it.
With spray in bed liner this should look okay.
Flipup plate to hidden hitch, backup camera, & air shocks filler.
Bumper is mounted with lower mount bolts so I can mark the upper holes
Want to do away with the old licence plate area.
Finished bumper with recessed licence plate, air shocks valve & backup camera.
Trailer hitch already moved up and back.
Curt Class III Mods for hidden hitch.
Curt Class III modified to fit behind the bumper.
Modified cross bar position and welded as well as bolted.
Surprised to see the full size spare still fits.
What do ya know, it works. I'm going to lower it 1 inch though.
Ideally I should have set the hitch 1 inch lower.
Monroe air shocks
When I take this apart to weld it, I'll lower the cross bar 1".
Machined and threaded 11/16 X 20
now to welding
Stuff out of the way.
Gusset cut off.
Cuts welded in
red wires hot with ignition. White wire DRL under bumper.
fan senders manifold ready to go into the upper radiator hose.
Sending units came in today.
waiting for senders and aluminum pipe stock
two relays wired up.
2 fans 2 relays 2 senders. 185* for left fan, 200* right
What's left of upper shroud.
Astro shroud and '98 Camaro fans
two alloy spacers
Painted this area as long as I was here.
Bolted in place
room to keep clutch fan whilst I figure out the wireing for the electric ones
I think this turned out well.
smoothed rear door
1st coat of bondo
glued on waiting for bondo